After doing a handful of calibration prints to make sure everything checked out, i began printing one of my own models, hollowed it out, sliced it, and started print. It looked great from the vat until I scraped it off the next morning and noticed there was some issue curing a portion of a starting layer which eventually corrected itself--here are some photos of da boi Notes; i did not put a drain hole in this model, ignorance is bliss :). this led to me poking a hole in an unstable portion of the model filling it with water, and draining it repeatedly until it was cleaned out. Although the print is technically a failure, im considering it a success all things considered.
